Pack of nuts, bolts, washers and terminals for fitting a pair of speakers and speaker rings.

Contains the following
12x M5 Bolts
12x M5 Flanged Nuts
8x M5 Stainless Steel Washers
4x 2.8mm Insulated Spade Terminals
4x 4.8mm Insulated Spade Terminals

Microphone for use with handsfree kits and after market head units with a 3.5mm jack mic connector

Mini HK (Harman Kardon) Enabler 

This HK enabler turns on the amp in HK mode in select Mini models with the fader set central. The mode adjust version comes with a small button which is used to adjust the fader & also access the different HK modes like driver, spacial etc.

Suitable for select Mini car models with the original boost CD radio and Harman/Kardon original amplifiers.

PLEASE NOTE: This is not a plug and play item. We recommend using 29-627 or 29-628HKM for a full steering wheel control solution.

Universal Automotive Sliding Door Contact Pad Pin Switch

This universal sliding door contact switch is designed to easily get power to the door lock actuators mounted in the sliding doors on vans. Used to install central locking motors in sliding van doors.

Designed to be mounted on the door frame area, these switches can also be used on the sliding or tailgate doors of cars, trucks and other automotive vehicles.

20mm HSS hole saw cutter drill bit.

Made from High Density Steel, this hole saw can be used to cut 20mm holes, such as those needed when fitting our CA-9401.V2 reversing cameras.

LED head torch with 12 high intensity LEDs

This 12 LED headlamp torch is useful for all sorts of applications around the garage workshop, at home or generally just out and about.

Give great visibility when working on a vehicle in the workshop, great for locating those dark hard-to-see locations during an installation.

The LED Headlight torch is also the perfect safety accessory to keep in your car for emergency use. Wear it in dimly lit areas so you can see and be seen, ideal for when you are out walking, cycling, fishing, camping or even as an additional domestic light for getting up in the night or reading etc.

PLEASE NOTE: Sold individually, colours and fragrances can vary

Auto Shine Car Air Freshener Extra Long Lasting Fresh Scent

Auto shine air fresheners add a pleasant fragrance, refreshing the environment while removing unpleasant smells. Their long lasting fragrance can be used in your car, boat or home.

ON/OFF panel mount toggle rocker switch. 19mm hole diameter.

Momentary panel mount rocker switch. Push and hold to activate the switch, springs back to original position on release. 19mm hole diameter.

Pack of 10 perforated galvanised metal strips. Ideal for use when custom mounting devices or units into cars.

Car Radio Fascia Adapter Metal Clips

Normally used when fitting our 50-938 fascia adapters.

Sold as pairs/ 2 Pieces Per Pack

Universal Side Fixing Brackets for Double DIN Car Radio Stereo Fascia.

Will fit a number of different fascias and have has cut outs to fit most Double DIN radios. Se long description for dimensions.

SOLD AS A PAIR

Enhance your car's audio experience with our premium pair of angled 6X9 speaker spacer rings, expertly designed for 6" x 9" speakers. These spacer rings feature an innovative angle that directs sound seamlessly into the cabin, ensuring optimal acoustics and a richer listening experience. With a depth of 30mm at the front edge and 45mm at the back, they provide the perfect fit for your speakers while minimizing distortion. Upgrade your sound system today and enjoy clearer, more powerful audio.

These adapters are popular with our BLAM range of Coaxial (BL-690RC) and Component (BL-690RS) 6x9 Inch speakers

A Pair of 6X9 speaker spacer rings for 6"x9" speakers

Speaker size: 6x9

Mounting hole diameter: 154mm x 227mm

Outer Diameter: 186mm x 260mm

Thickness 18mm

A Pair of 200mm (8") speaker spacer rings for 200mm speakers

Speaker size: 200mm (8 inch)

Mounting hole diameter: 182mm

Outer Diameter: 202mm

Thickness 22mm

A Pair of 200mm (8") speaker spacer rings for 200mm speakers

Speaker size: 200mm (8 inch)

Mounting hole diameter: 182mm

Outer Diameter: 202mm

Thickness 12mm

Hard wired universal FM modulator interface to add an aux in to a cars existing FM radio system.

Mini USB female to USB male adapter

Commonly used to retain original USB when fitting an aftermarket head unit.

Bulk pack of 10 Crimp Solder Plugs for DIN car aerial antenna adapters

Used when replacing the DIN aerial adapter

Bulk pack of 5 x 5 metre male Fakra to female Fakra in car radio aerial/ antenna extension cables.

This 5 metre (5m) aerial extension can be used when installing a new car aerial or to extend the Fakra connector when fitted at the rear of a vehicle.

It has a male Fakra connector at one end and a female Fakra connector at the opposite end.

Pack of 5

Male to female ISO connectors for connecting a European car radio to cars with ISO style connectors.

This cable is an extension of the iso wiring. It is useful on car radio's with recessed iso connectors in the back of the head-unit as the cables on the car loom may not be long enough.

ISO extension harness with switch on 80cm extension for manually switching on radio without having the vehicles ignition on. Commonly used on camper vans and motor homes.

Suitable for almost any vehicle with a permanent 12v feed to the radio using standard ISO connections.

Dual 2.1 Amp USB panel mount charging socket.

USB charging adapter 12V / 24V

USB charger for charging smartphones, tablets or laptops in cars, trucks, motorhomes or caravans.

Installation with 12V/24V power supply switched and fused.

RECOIL 3+8 Pole Busbar kit (3 x 3/8" inch terminal power distribution block) 

Eleven connections red busbar with 3 x 3/8? stainless steel studs and 8 x #8 stainless steel screws.

Eleven connections black busbar with 3 x 5/16? stainless steel studs and 8 x #8 stainless steel screws.

Comes with 3 x 8AWG 3/8”, 3 x 8AWG 5/16”and 16 x #8 insulated ring terminals.

The reinforced Polycarbonate cover attaches with nylon nuts to protect against accidental short circuits.

Max voltage:300V AC/ 48V DC. Max continuous amperage: 130A AC/150A DC.

RECOIL Dual/ 2 Pole Busbar kit (3/8" terminal power distribution block) 

These high-quality power distribution blocks allow for multiple connections to positive and negative systems.

Suitable for boat, car or caravan installations, each block can maintain multiple connections, making them flexible and robust for a variety of uses.

• Two connections with 3/8? stainless steel studs.
• Comes with 8 AWG 3/8” ring terminals and stainless-steel screws.
• Reinforced Polycarbonate cover attaches with nylon nuts to protect against accidental short circuits.
• Max voltage: 48V DC.
• Max continuous amperage: 250A DC

Drops 12V DC to 6V DC to provide a suitable power supply to a cars original parking camera.

Use with camera retention interfaces that do not have a voltage dropper built in.

PLEASE NOTE: This is not a camera interface. If you are looking to add or retain a camera please visit our car specific camera interface range

12V ignition spur from cigarette lighter or accessory power socket circuit. Comes with 10 amp fuse in the spur with a female bullet connection.

Use for hard wiring 12v ignition feed to radios where a CAN interface is not available or for dash cams and other accessories that require 12v with the ignition of the car.

Suitable for use with many European vehicles.

2.5m Power ISO cable extension cable with 8 way black connector.

This cable is for extending the power ISO cable on a hands free SOT lead or on an aftermarket car stereo audio head-unit.

Enhance your audio experience with our premium power ISO extension cable, designed specifically for extending the power iso cable on handsfree SOT leads and car audio head-units. This high-quality cable provides the extra reach you need, ensuring optimal connections and uninterrupted sound quality in your vehicle.

5m Power iso cable extension cable. 8 way black connector.

5 metre car audio speaker ISO extension cable. Consists of a 8 way brown female connector and a 8 way brown male connector.

This cable is used for extending the speaker iso cable on a handsfree SOT lead or on a car audio head-unit. If it is used for extending a SOT lead to the rear of a car, you will need two items to bring audio to the front and then back again.

Yellow Mini ISO extension lead 2.5m 

To be used when installing a new aftermarket head unit in select Renault Clio car models with branded amplified Cabasse units with Yellow Mini ISO connections.

The Cabasse system is normally an amplified system that has a separate tuner amplifier (not behind the radio)

The Amplifier tuner is normally under the passenger seat (looks like a CD changer )

To change the radio to aftermarket requires this cable to extend the cables from the amplifier tuner to the aftermarket head unit in the dashboard.

PLEASE NOTE: Should be used in conjunction with ISO extension cable (10-149 and 10-150)