BLAM KIT 165 S85 Active Two‑Way Component Car Speaker Kit

Designed for fully active car audio systems, the BLAM KIT 165 S85‑ACTIVE removes passive crossovers to give installers and enthusiasts full control over crossover points and time alignment via DSP or multichannel amplifiers. It features 165 mm S6.85 woofers with a beryl-carbon composite cone and 25 mm T25HR soft-dome tweeters with a neodymium motor and low-resonance rear chamber. This kit is engineered for high‑end installations requiring detailed tuning, wide frequency extension (45 Hz–40 kHz), and a dynamic, natural response. Exclusively distributed in the UK by InCarTec and supplied worldwide to premium car audio specialists and retailers.

Key Features

• Active 2-way car speaker kit – no crossovers included
• 165 mm S6.85 woofers: 100 W RMS / 200 W max, 3 Ω, 45 Hz–5 kHz
• 25 mm T25HR tweeters: 15 W RMS / 100 W max, 4 Ω, 1.5 kHz–40 kHz
• Built for DSP-controlled or fully active amplifier systems
• Wide frequency range and high output for detailed soundstage
• Supplied by InCarTec, UK distributor of BLAM Audio

Composition

2 X S 6.85 HIGH FIDELITY WOOFER/ SPEAKERS

• 6-1/2” (165 mm) woofer
• Maximum power 200 W / Nominal power 100 W
• Frequency response 45 Hz – 5 KHz
• Impedance 3 Ω
• Die-cast aluminium basket
• Ultra-rigid beryl-carbon cone
• NBR cone
• Long-life “Conex” spider
• 32 mm voice coil
• Glass support
• 85 mm x 20 mm Oversized magnetic motor
• Machined poles
• Gold-plated terminal block.

 2 X T25 HR HIGH RESOLUTION TWEETERS

• 25 mm (1″) soft-dome tweeter
• 4 Ω, high-efficiency noedymium magnet (N38H)
• Precision-machined aluminum faceplate
• Low-resonance rear chamber
• Large protection roller for wide dispersion
• Transparent protective grille

S 6.85 Technical Specifications Sheet

T 25HR Technical Specifications Sheet

You might also require (Sold Separately)

• Trim Panel Tool Set - A must have for any installer who has to remove plastic trims, to avoid damage to the delicate finishes on both interior and exterior dashboards and panels. These trim tools are made from a nylon with a non-damaging finish to avoid cosmetic blemishes to the interior or exterior of your vehicle from removing panels and trim.
• Speaker Grilles - If your car speakers are exposed then use speaker our 165mm Grilles for a more discrete appearance and offer a form of protection to kicks and knocks.
• Sound Deadening - Sound deadening can vastly enhance your vehicles sound upgrade by reducing sound vibration, eliminating outside road noise and creating a more acoustic environment, magnifying the sound quality of your system.
• Sound Deadening Tool - Professional sound deadening roller tool designed to allow even pressure when applying sound deadening on the surface of the car, minimising air bubbles and helping to achieve the best possible adhesion. 
• Speaker Baffles - Designed to fit any 165mm speaker, these adjustable speaker baffles creates a flexible seal around the back of the speakers, protecting them from water that gets inside doors and interior panels. Additionally it provides a barrier stopping interference between sound from the front and rear of the speakers from having a negative effect on sound quality.
• Led Headlamp Torch - Gives great visibility when working on a vehicle in the workshop, great for locating those dark hard-to-see locations during an installation.

• Disposable Gloves - Offer great protection for your hands during installations. Also trusted across various sectors, including automotive, agriculture, healthcare, food and catering, manufacturing, and more.